Skip to main content

I have a DCS system with a Command tethered to it.  I purchased a Legacy 2-8-8-2, programmed it into the system and it works great.  I just recieved my new Legacy 4-8-4, programmed it in, not so good.  It runs ok for a few moments, then the smoke shuts off and the cab lite starts flashing at regular intervals.  I applied more ground wire, with no improvement. 

The proble persists on the entire layout, including my programming track (which is isolated from the rest of the layout)

Help is much appreciated

Brad

Original Post

Replies sorted oldest to newest

My personal theory is that the system might be a teeny bit oversensitive to any excess current draw by the fan motor. If slightly too much smoke fluid is added it is easy for some to find its way into the fan housing and create some drag.

The front smoke unit on my DD35 is very sensitive to this since new (Initially it was jammed solid by incorrectly fitted wicking as delivered, so this may have weakened the motor.) and I have found that if I turn the unit off and wait a few days, the fluid disperses and it will work again.

Post
×
×
×
×
Link copied to your clipboard.
×
×