Precision craft On30 goose issues

Russ, thanks for the input! It was weird...had the track power on in DCC on the bach EZ and as soon as that rear truck touched track it started the engine start up sound sequence, even without a 1-9 channel being set yet{was on 1}...tried it in anolog and it did the same thing the same way. Had a headlight the 1st few times playing with the channels but after that it went out and stayed out. 

I haven't played with the dynamis yet, but I think this may be a fine time to do so! The dynamis only goes to 20 channels and I've heard other DCC controllers can have more than that...need to figure out the full factory rest CV and go from there...Do you remember what channel your geese were...or are if not changed.

Oh, your added thoughts sir...this unit is missing the bell on the front fender...what would be a good replacement for it...iyho? 

I had it and I lost it...my life's story{hehe}. Was trying to figure out the dynamis ans was re CVing the goose when I got it to drive in both directions...lights wouldn't stay on, but it was working...then I was trying to rest soemthing else and I lost it again. CVing is a learning experience with the dynamis..or in general for me.

I got it!...whoo hoo....finally figured it out. With the loksound and a dynamis I can't rewrite CVs while on the "maintrack"...only happens on the "service track"...that's why I lost it..I was in the wrong place that time.

This dynamis is gonna take some getting used to, but at least my goose can waddle now!