Quick question. I have a project where I'd like to run four 3mm LEDs off the front number board circuit on a PS3 diesel board. The most I've seen is two 3mm LEDs on that circuit. I'm curious if the circuit will support the two extra LEDs.
Replies sorted oldest to newest
Lou, I believe you can. I recently had a factory PS3 Diesel apart in which all four number boards were powered from the same circuit.
The LED outputs should be current limited, so it would probably work, just less brightness of each LED. Since it typically powers one LED, my guess is it's limited to around 20ma.
Well I've got six 3mm LEDs on the number board circuit (two in the rear, four in front) and it's working fine. Ran for an hour and nothing blew up, so I'll call it good.
Access to this requires an OGR Forum Supporting Membership
