I have a brand new PWC F3. I need advice on taking the shell off. I see the screw at the nose and the two clips at the rear end. The book says to unclip these for removal. I see how it's supposed to work but am concerned about how much pressures I should use. Thank you
Replies sorted oldest to newest
I believe you should be able to remove the screw on the nose, lift the nose a bit, and slide the shell forward to disengage the clips from the frame. Shouldn't take a lot of force to do this.
Thank you very much. Can't wait to try this after work. The booklet never mentioned sliding the shell forward. Makes sense now
ricka1 is absolutely correct - however after lifting the nose slightly sliding the cab forward is not always easy - you may need to gently tap on the rear of the cab with your palm and nudge it forward then it should lift off - also when lifting the cab away from the frame be careful there are wires attached to the roof of the cab
Access to this requires an OGR Forum Supporting Membership
