Skip to main content

1 reply

Replacement Wireless Drawbar for Tinplate 384e - what size and who would have them?

CaptaincogCaptaincogOGR Forum Member DIGITAL SUBSCRIBER

Okay, so I have the Lionel Corporation Tinplate 384e Part number 11-5010-1 that has PS 3 and the connector on the wireless drawbar to the tender cracked a while back so the engine sometimes stops because of the poor connection....so I need to replace it....

What part number and who has them? I would like to get a couple so I have a spare since I do train shows and events with the tinplate. I have looked on the MTH website and tinplate parts guide along with internet searches without finding this information.

Thank you!

 
Last edited by Captaincog
Original Post
bruce benziebruce benzieOGR Forum Member

Drawbars come in different sizes, which can be seen on the top surface.  They are listed in mm,

your engine MAY have either a 35 or 40 mm drawbar.  Tinplate engines use a vertical connector, tender a right angle

connector.  The 35mm vertical/right angle drawbar is p/n FB-0000016, the 40mm is p/n FB-0000017.

MTH dealers may have them or order from MTH.

bruce

Add Reply

Views: 146
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×