PS3 engine run on my dcs commander with address changed by me to "3".
Did all three resets (features, factory and system) on dcs commander trying to get it to respond to my dcs remote on a different layout.
The resets changed the address to "1" and I assumed that was the factory address. But it still won't respond to the Dcs Remote commander.
Do I not have the correct factory address to use with my dcs remote commander?
Thanks for any help.
Bill
Replies sorted oldest to newest
Bill,
How do you know it ws changed to "1"? If you know because you re-added it to the DCS Commander, by adding it you made it so it cannot operate with the DCS Remote Commander.
Just do a Factory Reset and do not add it back. Then, just run it with the DCS Remote Commander.
For a complete explanation of DCS ID#'s, refer to The DCS Companion 3rd Edition, Appendix E: The Truth About DCS Engine ID Numbers.
This and a whole lot more is all in“The DCS Companion 3rd Edition", available for purchase from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book.
Ok...that does make sense.
Do the reset and then pick it up off the track.
Thanks for the reply. I'll try again tomorrow.
Bill
NO! Do the reset and UNPLUG the brick from the DCS Commander. Do Not pick engine up off live track. Let the engine shutdown. Remove engine and place on DCS Remote track, but wait 1 minute before trying to run on DCS Remote. G
Understood.
Thank you both for your replies.
Bill
Success!
Thanks again for your help.
Bill
Access to this requires an OGR Forum Supporting Membership
