Hello,
I am new to the hobby and not too technical with the new equipment available today. I have a Lionel 0 gauge set that was gifted to me. This is where I am stuck: I created a nice layout operating two locomotives on one table. The two rails do not touch each other (they run in opposite directions). I am using Lionel PH-1, powerhouse and PM-1, powermaster to power each track. I use a CAB-1 remote to operate the system. I have assigned a different track number to each track. When I operate one of the tracks both locomotives respond at the same speed. I can't seem to correct this. Any suggestions would be helpful. Thank you so much!!
Jim
