Skip to main content

Wired up a command base with Legacy system using the DB-9 supplied cable with the ground wire to the legacy base today at a show for tomorrow. Have not used this base in a few years carrying it around in a box with other transformers, powermaster, and other layout stuff I use to set up at shows.
The green light comes on the base and when I use a cab1, it is not communicating with the base as the red light does not flicker. I verified that the base crystal is good as I swapped it with another base at home. And the cab1 I was using there works on the base at home. I did try the alleged bad base at home and nothing happened. Only the green light comes on.

Anyone have an idea what is going on with the TMCC base and/or can fix it?
Thank you.

Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×