I just got these a day ago. Using the gar graves track for the crane can I hook the higher voltage accessory side of the Z4000 to the outer rails of the gantry track tying it in with legacy to control both the crane and shed. I am thinking the voltage must be about 14 volts rather then tie into track power at a higher voltage. All help greatly appreciated..............Paul
Replies sorted oldest to newest
According to the instructions the crane takes track power which is 18 volts. The sounds workhouse calls for 12-14 volts.
Thanks Charlie. I had not read the crane directions yet but had looked over the shed. What I was hoping for was to be able to run the crane at the same voltage off the accessory side....................Paul
Access to this requires an OGR Forum Supporting Membership
