Skip to main content

I had a local "old timer" bring me an old engine to look at. 
The motor was froze, so I pulled the armature and cleaned the shaft and bushings. Spins great now.

This wire was not connected, I assume I solder it to the terminal where the green fabric covered wire goes on top of the brush plate?

Brushes weren't bad- I'm going to polish the commutator a little before reassembly.

TIA-

 

 

 

Attachments

Images (2)
  • 79214721_1253130698211909_7321308536749686784_n
  • 80080113_579044626250801_2587014271606980608_n
Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×