Someone was recently looking for one of these, and now I can't find the original post. I had stated that I may have one if I found my box of smoke units. Well... I did find the box... However, I don't know who was looking for the smoke unit! 
Replies sorted oldest to newest
John, it was on 5-22-18
Yep, but I can't find the thread. 
The attached photos are both sides of the burned-out circuit board from a K-Line Crusader smoke unit. Also pictured is the entire smoke unit with board removed. Would anyone know where to find the board, with attached resistor and gasket? I would be happy to find the entire smoke unit if it comes with resistor board pre-installed.
TCA member since 1974.
You may want to see if an American Flyer Smoke unit would work. Someone told me the K-line smoke units were American Flyer copies. Otherwise contact Brasseur trains as they purchased the last of the K-line parts.
member:Golden Spike Club Charter Member
Let me check my parts, I used to have a couple of these, and I did an upgrade of the Crusader to fan driven smoke, so one of them should be that unit.
John, if you have no luck, I also did a Crusader and I keep everything.
TCA-79-13758
T.T.O.S.-3057
LCCA-28444
LOTS-RM-4833
MTH Railroaders Club-17209
MTH DCS and Wi-Fi Beta Tester
MTH Factory Certified Technician-6 schools. Repair Technician #990284
LIONEL Factory Trained Certified Repair Technician #10140
Member Mid America 3 Railers and NJ HiRailers
I have not turned up the box of smoke units yet, so if you have one, I suspect that will be quicker. I know I have one, just don't know which box it's in!
Thanks for looking--keep me in mind if it turns up. I can get a few parts from Brasseur Trains, including the resistor board. I'll have to fashion a gasket.
Marty, let me know if you have one for sale.
TCA member since 1974.
So Jon can you get your Supa Chuffa to work with that?
prrhorseshoecurve posted:So Jon can you get your Supa Chuffa to work with that?
Sure. 
Access to this requires an OGR Forum Supporting Membership
