Greetings,
If I understand the Greenberg manual instructions correctly, the adhesive washer is adhered to the top of the coil assembly, and the driving washer is adhered to the other side of the adhesive washer. Right? I want to make sure I am putting this together correctly. I would appreciate it if anyone could post a drawing or image of how the washers are put in place.
Thanks.
Replies sorted oldest to newest
What I do is use a little Goo to attach the drive washer to the inside of the top o that the fingers are down when top is in place. A little graphite powder on the drive coil doesn't hurt either...
Marty
The adhesive washer is attached to the inside of the lens bracket assembly, and the driving washer is then attached to the adhesive washer. (Fingers down as Martin noted.) I have never had to replace the adhesive washer, but have done the drive washer many times. Don't fasten anything to the top of the coil, it is the surface upon which the drive washer turns!
Thanks, GN Man. You explained it perfectly. And thanks for the link to the manual page, which I printed and have put in my book of instructions.
Access to this requires an OGR Forum Supporting Membership
