I have a Legacy Lionmaster Big Boy and I have a new problem. The engine starts up in conventional mode but I can move it forward, backward and control speed with Legacy, but I don't have any chuff, bell, whistle or dialog. I did have the tender on the track powered up for a few moments while I put a new wick in the smoke unit. Any ideas would be appreciated. Is there a reset command in Legacy I can't find anything in the book about it.
Replies sorted oldest to newest
The Legacy reset is the number 1 if it is an early locomotive with mudular boards and if it is later with the RCMC board just use your engine ID as you would do in a regular reset. What is your Lionel number 6-_____?
Marty,
It is 6-11208. Can you explain the Legacy reset procedure to me? Thanks, Brad
Brad,
The reset procedures are on page 18 of your manual, here
http://www.lionel.com/media/se...4711208250BigBoy.pdf
and here for other Lionel engines except the ones using a RCMC
http://www.lionel.com/ForTheHo...oreTMCCfunctions.pdf
Bill
Thanks Bill. I did see that reset procedure for TMCC but I assumed there was a seperate procedure for Legacy. I stand corrected.
Access to this requires an OGR Forum Supporting Membership
