Hello all,
I recently put an addition onto my layout, with WiFi (#4) and TIU (#4). It all seems to have proper connectivity, but the DCS Signal does not get to TIU #4 or the new section of track. How can I trouble shoot this issue, and find the cause? Thanks to all.
Mike H.
Replies sorted oldest to newest
I would take both and connect to a short piece of track to troubleshoot this. Eliminate the layout and the wiring. Zero in on what's working and where the problem is.
Maybe you could swap the TIU #4 with TIU #3 for example and see what works. Do you get voltage right now to the track where TIU #4 is? Was this TIU used? Did you reset it? (or make sure the DCS signal is turned on)
Question not understood since the DCS track signal is generated by the TIU. Does the LED in the new TIU blink 4 times when powered up? If you have a remote, have you added the TIU to the remote? Have you turned on super mode for TIU#4 in both the TIU and all remotes?
Access to this requires an OGR Forum Supporting Membership
