Question about legacy base & Charging

Normal so far.

cjack,

    Well the lights went solid red and I took the Cab2 off the base, let it cool down and

put it back on, and everything finally started blinking green then went solid green so it looks like the Cab2 is now fully charged, and I can go on from here.  cjack what size wire are you running from the legacy base to the track?  Can't find a specification for it in the Legacy instructions.  The hole in the legacy post is not all that big.

PCRR/Dave

Hey Dave,

The gauge ground signal wire to the track does not have a be a large wire so 18-20 gauge wire will do. I would recommend a banana plug connection for the legacy base since it will make good contact and easy to unhook should you need to do so.

Your battery charging cycle is correct. You could leave the CAB2 in the base with the dual flashing red lights and the system will cycle back to charging once the batteries cool down.

I hope this helps.

When the lights go solid red my experience has been that sometimes you have to take the remote out to kick-start the process again.  I've left it there overnight and in the morning it's still in the same state.

Since I got the charger fixed, that hasn't really been an issue, so maybe mine was the batteries.

Guns,

   Looks like mine is now working correctly, shut everything down last night, turned it on this morning and it recharged itself like intended.  Thanks for the help, I will probably have other questions as the DCS/Legacy Christmas layout is constructed.

PCRR/Dave