Can I daisy chain trainmaster accessory motor controller behind a legacy accessory motor controller. If not does someone make a Y db-9 plug that I could use to plug them both to the legacy base
Original Post
Replies sorted oldest to newest
Yes, it's called the SER2 module. If you are going to use LCS- most folks at some point need or desire to use a SER2 module.
http://www.lionel.com/products...rter-2-ser2-6-81326/
Notice the green screw terminal area- you now use that rather than the DB9 cable.
Instructions https://www.lionelsupport.com/...50SER2UsersGuide.pdf
page 12
Attachments
Images (2)
Again, a trainmaster AMC, is a 2 wire device, receives commands only. So if you use a serial 2, you can use the screw terminals for the 2 wire serial interface AND have the DB9 serial interface free for other uses.
Also, I would read this topic as well. https://ogrforum.com/...4#162616683194363034
Again, topics like this, the AMC/ARC Log loader is basically the TMCC AMC- just slightly different firmware, but again many folks are using this setup https://ogrforum.com/...e-amc-arc-log-loader
Thanks for taking your time to answer my question.
Okay if I have this right I will need a ser2 and an extra PDI cable to connect the new LCS modules to the existing TMCC modules . Thanks Vernon
