Smoke Unit Fan

USCGRETOGR Forum Member

I have a Lionel TMCC Centennial Diesel Engine (6-18268) with a Smoke Unit and Fan. I think I have a programming issue. I can hear the fan intermittently surging off and on. Previously I recall having this issue, but can't remember how to fix it (how to re-program it). It is programmed in TMCC mode (it is a TMCC engine). Any suggestions hear would be greatly appreciated .

3/4/136:24 PM

❤️ 0

Original Post

Replies sorted oldest to newest

Alex MOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

Hi USCGRET

HERE'S THE INSTRUCTIONS FOR THE REPROGRAMMING FOR THIS ENGINE

TrainMaster Command operations
18
Reprogramming R2LC circuit boards to restore features
STEP 1: Move switch on locomotive from
run to program.
STEP 2: Turn on Command Base.
STEP 3: Place locomotive on track, then
turn on power to track.
STEP 4: Press “ENG” then input locomotive’s
ID#. Press “SET”
STEP 5: Press “ENG”, then the ID#,
“AUX1”, then press 8 for your locomotive.
STEP 6: Turn off power to track, wait ten
seconds.
STEP 7: Remove locomotive from track,
move switch from program to run.
STEP 8: Place locomotive back on track,
turn power on to track.
STEP 9: Press “ENG” and ID#, then operate
as normal.
Due to the inevitable derailments and
static, it is possible that your R2LC
could someday lose its setup program.The
symptoms of this condition would be unresponsiveness
in command mode. This can
be easily remedied by “reprogramming”
your R2LC using the following steps.
To program your R2LC as a diesel locomotive with smoke, follow these steps.
(These steps will also restore programming which is accidentally lost due to
static, numerous derailments, etc.)