Skip to main content

I am very frustrated.  I have a Kline GG1 with factory lionel TMCC.  The engine ran great for years but......  I have horn, bell, front and back couplers.  No rail sounds and will not run.  I have put all new boards in it to include DCDS, Sound, Power, radio, and motherboard .  There is power into the DCDS but none out.  All wires and harnesses have been checked for continuity.  Tried to reset engine code but that did not work.  Any ideas???? Hoping someone might have had a similar experience

Mel

Last edited by OGR CEO-PUBLISHER
Original Post

Did you check continuity from back of pins on DCDS with connector plugged in.  Some harness are notorious for being good as harness, but have loose/corrosion on connectors and do not actually make contact with pins.

Also, check each component in another know good TMCC engine.  Both the GG-1 original stuff and the new stuff bought.  Prove what works and does not work before putting those components in the bad GG-1.  But it does sound like a wiring problem, so go back and check it again.  G

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×