I have three concentric loops of track, electrically and mechanically isolated. I have two TIU's. One TIU powers two loops and uses aux. power. The other unit powers the third loop with track power. Only one hand held unit. All are 3.1 levels.
DCS acts funny when all tracks are powered. Hand held unit reacts very slowly, if at all. Turn off third loop and everything is normal. what is happening with the TIU's? Are they interacting? How can I solve the problem?
George
Replies sorted oldest to newest
Dumb question, do you have the TIU's addressed as #1 and #2? If they're both #1, I'll bet that would confuse the **** out of the remote! 
Hope this helps.... How do you know what number your tiu is?... When you power up a tiu there's a red LED on top that blinks. The number of blinks is the actual tiu number.(up to five)
How many times does each of your tiu blink? unfortunately the software will allow you to add tiu even though they may not exist. Far enough for now... come on back.
They are both straight from the factory. Probably both set at 1 from the factory.
I will check it out this weekend
George
They are both straight from the factory. Probably both set at 1 from the factory.
I will check it out this weekend
George
Well, that would be a problem, I suspect fixing that will fix the delays. 
They are both set at "1". How do I set one to "2"?
George
George,
They are both set at "1". How do I set one to "2"?
As follows:
That should do it. The old TIU will be #1 and the new TIU will be #2.
This and a whole lot more is all in "The DCS O Gauge Companion 2nd Edition", now available for purchase as an eBook or a printed book from MTH's web store site! Click on the link below to go to MTH's web page for the book!
Access to this requires an OGR Forum Supporting Membership
