Skip to main content

I have a zw-c ,4 bricks, legacy and tmcc hooked together. It just started that when I have everything powered handles A &B work together.Even with all the bricks off except for handle A brick,the A and B work together with the remote or the handles.Handle A will not go below handle B.I reprogrammed the ZW 1-4 with no change.

Any ideas

Bob

Original Post

Replies sorted oldest to newest

When changing out my ZWC last night to a ZWL I accidently had the hot side of the D side come off a connector on one of the DPDT switches in my little box that I use to route power to my block sections. I was moving controls to make room for the ZWL so prior to pulling the ZWC offline I powered up and the disconnected channel D was showing 9 volts so I went looking and found the issue. Maybe something similar?

I hope this helps.

I removed 1 of 2 wires from B and the ZW acted correctly.Put it back and the problem reoccurred .one of my switches that I just hooked up does not light when I remove the plug.the sc2 that it is attached to I removed the ground from the switch to remove the sc2 from the system,powered down. This was happening with the ZW so I disconnected the SC2 to diagnose the problem,it did not help.Only taking wire off of B did it.

Post
×
×
×
×
Link copied to your clipboard.
×
×