Skip to main content

3 replies

20-3617-1 Will not power up in conventional mode.

RJTRJTOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

I just installed a new Z4000 and run several Post War locomotives in conventional using the Z and no issues. I put on the MTH 20-3502-1 S1 and it powers up but will nit run like it is locked in neutral . I also put on my 20-3617-1 Class A and it will not power up at all. Both of theses locomotives were operating normally when I took down the earlier layout and I was running MTH DCS/WiFi. Not I just want to run them both conventional for now. Any suggestion?

Original Post

Replies sorted oldest to newest

Add Reply

Views: 377
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×