Well, TIU1 and TIU3 are working great, TIU 2 is working but seems to have trouble passing signal, Engine runs through block 2, but horn sticks on. TIU 4 is my last big hurdle, it is not passing voltage from Fixed 1 in to Fixed 1 out. Have reset TIU4, no improvement, I went to DCS setup and made it a Super TIU, and I turned on the port in the TR settings. Any thoughts?
Replies sorted oldest to newest
Yes ...
1. As I understand it, Super TIU Mode is used so that the remote can control all engines on a layout using multiple TIU's, regardless of which TIU a particular engine was last associated with. However, in order to be effective, all TIU's on the layout must be switched to Super TIU Mode.
2. If Fixed 1 is not passing voltage, did you first try Fixed 2 or changing a variable channel to a fixed channel and using that ?
Check the fuse for FIXED 1 inside and the nuts on the dual banana plugs while in there.
I fuse was blown, I can only assume it is fixed 1. Alot of the screws were loose, that kinda surprised me, going to have to check my other TIUs. Will give you all an update tomorrow. Thanks for the help...........
Access to this requires an OGR Forum Supporting Membership
