my mth triplex preium proto 2 engine will not start up either conventionally or with the dcs system-is the power board dead or is their a process to reboot the engine-thxs
Replies sorted oldest to newest
Check to make sure the tether between the engine and tender is firmly in place. If it is loose or disconnected the best way to access it is to remove the large screw securing the tender to the engine. The, you will have plenty of room to secure the tether. Then, engage the shaft that powers the tender drivers and reattach the screw securing the engine to the tender.
thxs-i will try that suggestion again but when a apply power to the engine the only noise that i hear is a short click coming from the tender both conventionally a with the dcs system
Could be a bad board or component short on the board. Depends on which model. Need a tech to test board and repair. G
The Triplex is the most complicated of all engines to work with. First thing is to check the connections between engine and tender, This connection had a male/male plug in the engine. Both the engine and tender connect to it. The tender tether is very short and can pull out of the connector. You can not see the engine connector without a lot of close examination.
Bruce