Hi this weekend as almost every week weekend I was running my layout . Every thing was running fine until I wanted to change to my f units when I did that the f units turned into a run away how can I fix this problem I can’t even go to reset engine on my I pad it’s that quick. Thank you bob as you can see it was running normal in video
Replies sorted oldest to newest
Try a conventional reset. You cannot do this with an ipad or wifi or remote. There must be no DCS signal, so it is done from transformer. Press whistle button once and then bell button 5 times, with 1/2 second pause between them. If engine responds with 2 toots, you've succeeded. If not, try again.
Thank you I will try it. One thing how do I stop engine from running away.bob
Thanks RJR I wasn’t thinking clearly using conventional transformer I can control the runway problem as with the dcs I can’t thank you again.
You'll need to apply 9-10 volts. A long train or a hand can keep it from zipping away
Thanks again RJR
Access to this requires an OGR Forum Supporting Membership
