I'm converting my Galloping Goose PS1 (boards for sale on other forum page). I need to know what the wires are going from the box to the cab. One white, one yellow, one black, and one white. Once inside the cab they are two whites and two blacks! Anyone know the pinout going from the box though? I wanted to use the existing wire and plug on the cab to keep it clean. Also, are they 12v bulbs in the cab that will survive full power for long?
Thanks for all the help guys!
Replies sorted oldest to newest
John,
Tell me if they are bayonet or screw base. I will then email the correct replacement bulb numbers to you.
The numbers I give you will be for bulbs you can run at full power. And these bulbs WILL NOT GET HOT & WILL LAST FOR YEARS.
You will have to tell us what they connected too in the box at the PS-1 board?
But, the cab light interior is 18V and probably tied to AC input.
The 2 head light bulbs are 1.5V and will need to be replaced. They may have had a blue plug and went to the blue directionally controlled connectors near the rectifiers on the bottom board via the harness. Though on early stuff they may have been direct wired to the PS-1 board. G
The bulbs didn't look replaceable pappy. I would think they should be though. I need to take a closer look.
Thanks GGG. Yeah it was a blue plug all right. Darn it, I was hoping to use the existing headlights as it looks tough to replace those. Oh well, I'll do it!
I'll just have to redo it all! I'll post pics when done!
Ok the bulbs sound easily replaceable. They just push in from the back according to instructions. Maybe this won't be so hard after all.
Access to this requires an OGR Forum Supporting Membership
