Greetings,
I’m get the gumption up to wire my No.60 Trolley. I have my solder station ready with a new solder tip, solder and flux. I bought a refurbished field assembly and brushes from the Train Tender quite a while ago but do not have a visual guide on how to perform this work or know the correct gage wire to use. Your expert views with images would be greatly appreciated!
Rudy
Replies sorted oldest to newest
Use either #22 or #24 wire. Get something with wire soft insulation, something like super flex. I would recommend you get some soldier wick, pre fluxed, to remove the existing solder before trying to disconnect the wires. Test as you go. If you get the field wires on the wrong terminals it will run, but it would not reverse.
I do appreciate your efforts however, I really need clear views all the way around to see where the wires are coming from and going to.
The view of the wiring is very difficult to see where the wires coming from the field assembly and the wire from the rollers are going to.
Is it possible someone could expose their trolley or gang car and post images for me? I am not good at understanding the schematics.
Thank you.
I’ve refurbished 5 trolleys so I learned this via hard knocks. The pic you posted is so helpful for newbies. Thanks!
Just be careful with the wires coming off the field assembly. After 60+ years they’re a bit brittle and have a tendency to break at unexpected points.
Access to this requires an OGR Forum Supporting Membership
